Gday, the aftermarket model a (30/31) headlight bar, as suspected doesnt exactly sit nice on the my fenders, can the aftermarket stainless headlight bars be bent/tweaked with problems ?, i assume the ends are cast and the middle section is just tubing ?
any pitfalls to avoid ?, assume i will need to heat up the ends to get the right angle
Thanks
Warren
Stainless headlight bar - model A
-
chop_shop
- Senior Member
- Posts: 1214
- Joined: Tue Dec 27, 2005 5:40 pm
- Location: Lilydale, Vic
Stainless headlight bar - model A
“Any fool can know. The point is to understand.”
― Albert Einstein
― Albert Einstein
-
zuffen
- Senior Member
- Posts: 1696
- Joined: Fri Jan 28, 2011 7:45 pm
- Location: Sydney
Re: Stainless headlight bar - model A
If I was in your situation I'd take it to a stainless steel fabricator and let him advise you.
We can all offer opinions but stainless is a bit more tricky than mild steel to play with.
We can all offer opinions but stainless is a bit more tricky than mild steel to play with.
Never argue with an idiot, they will drag you down to their level and beat you with experience.