All fine but a very weak spark, engine will not start.

Go here for posts about rebuilds, parts and problems
Post Reply
32chevy
Posts: 94
Joined: Wed Nov 23, 2011 1:53 pm
Location: North of Brissie and east of the place to the west

All fine but a very weak spark, engine will not start.

Post by 32chevy »

Hi,
The engine in the rod will not start. So far checked all of the below

Battery very good
Fuel pump very good
All lights and dash lights work
Starter cranks full bore
Petrol tank 3/4 full
Fuel squirts in the carburettor at crank

The thing will not start
Checked the spark with a spark plug removed and held against the engine
block cranked the engine and the spark is very weak.
I am at a loss what it could be.
Any pointers will be most welcome.
No matter where I go, there I am, spooky
hudson nut
Posts: 419
Joined: Wed Mar 25, 2015 4:50 am
Location: Riverside Calif.

Re: All fine but a very weak spark, engine will not start.

Post by hudson nut »

It sounds like the gap has closed up on your points.

Dany
25 Hudson speedster project
29 Hudson coupe
36 Hudson 4dr sedan
36 Hudson LWB 4dr sedan
40 Hudson 2dr sedan
41 Hudson coupe
54 Hudson coupe
User avatar
FRANK BASILE
Old Hand
Posts: 13895
Joined: Wed May 07, 2003 3:14 pm

Re: All fine but a very weak spark, engine will not start.

Post by FRANK BASILE »

What engine, what ignition system ? This may help suggestions. Crook points will be a start if points type. Crook coil . Weak spark also if the bypass is not connected ,this gives full volts across coil when cranking . Points coils are 8volt running through a ballast on normal run ,when cranking the ballast is bypassed so voltage drop does not affect the coil supply adversely. I assume that the engine was normally starting beforehand anyway so this can be discounted. Or if electronic HEI system without points the module could be suspect.
OZ-E-Rodders Rod and Kustom Club Member #31
32chevy
Posts: 94
Joined: Wed Nov 23, 2011 1:53 pm
Location: North of Brissie and east of the place to the west

Re: All fine but a very weak spark, engine will not start.

Post by 32chevy »

Thanks for the replies.
The engine is a SBC, with carby. Was running until a couple of weeks ago. Tried to start it a few days ago, and no go as described. I will go over the wiring in the coming week to make sure there is no short anywhere.
I will come back after that.
No matter where I go, there I am, spooky
User avatar
FRANK BASILE
Old Hand
Posts: 13895
Joined: Wed May 07, 2003 3:14 pm

Re: All fine but a very weak spark, engine will not start.

Post by FRANK BASILE »

Unlikely to be a short. Nothing at all would be the result. Does it have points? . Check that they are ok, and the small earth strap grounding the breaker plate to inside the distributor to the housing is ok.
OZ-E-Rodders Rod and Kustom Club Member #31
Thomobro
Posts: 61
Joined: Tue Jun 17, 2014 10:08 pm

Re: All fine but a very weak spark, engine will not start.

Post by Thomobro »

Check points condenser
Faulty condenser will give weak spark
Thomobro
Posts: 61
Joined: Tue Jun 17, 2014 10:08 pm

Re: All fine but a very weak spark, engine will not start.

Post by Thomobro »

Check points condenser
Faulty condenser will give weak spark
Greg N Smith
Senior Member
Posts: 1070
Joined: Thu Jan 05, 2006 1:47 am
Location: Sunshine Coast QLD

Re: All fine but a very weak spark, engine will not start.

Post by Greg N Smith »

Have ya tried a good squirt of Start Ya Bastard ?
User avatar
HOT ROD FRED
Old Hand
Posts: 2521
Joined: Thu Apr 06, 2006 8:23 am
Location: Ringwood,Vic

Re: All fine but a very weak spark, engine will not start.

Post by HOT ROD FRED »

Is your coil ballast resisted? Check that the resister hasn’t burnt out
User avatar
steve the ford guy
Senior Member
Posts: 1576
Joined: Mon Apr 19, 2010 9:36 pm

Re: All fine but a very weak spark, engine will not start.

Post by steve the ford guy »

Greg N Smith wrote:Have ya tried a good squirt of Start Ya Bastard ?
Yes if there's no fuel in the cylinders or manifold from sitting a long time you'll need to try this first
User avatar
FRANK BASILE
Old Hand
Posts: 13895
Joined: Wed May 07, 2003 3:14 pm

Re: All fine but a very weak spark, engine will not start.

Post by FRANK BASILE »

I should have asked, when it last run?.
OZ-E-Rodders Rod and Kustom Club Member #31
User avatar
jeffa
Old Hand
Posts: 4476
Joined: Thu Sep 18, 2003 4:50 pm
Location: Canberra, Australia! Best country on the planet!

Re: All fine but a very weak spark, engine will not start.

Post by jeffa »

FRANK BASILE wrote:I should have asked, when it last run?.
Hi Frank.
As per OP's previous: "Was running until a couple of weeks ago."

He didn't say what sort of ignition though.
Yeah. I've changed my signature. The old one was out of date...
What if climate change IS a hoax, and we make a better world for nothing?
User avatar
FRANK BASILE
Old Hand
Posts: 13895
Joined: Wed May 07, 2003 3:14 pm

Re: All fine but a very weak spark, engine will not start.

Post by FRANK BASILE »

jeffa wrote:
FRANK BASILE wrote:I should have asked, when it last run?.
Hi Frank.
As per OP's previous: "Was running until a couple of weeks ago."

He didn't say what sort of ignition though.
Yes jeffa. Makes a difference to the fault finding . A crook module can also produce a weak spark. Had one do that in a VH Commodore HEI . Similar if the module is not earthed properly. That earth is via one of the Bosch module cover screws on the distributor clamping it..
OZ-E-Rodders Rod and Kustom Club Member #31
Post Reply